The authors would like to make the following corrections about the published paper [1]. The changes are as follows: In Table 1, there was a mistake in the laminate configuration of the embedded inserts. UD [(0°/90°) ₈] _s was written instead of the correct UD [(0°/90°) ₄] _s. The corrected Table 1 appears below. There was a mistake in the captions for Figures 11 and 12. The use of externally provided images by Fraunhofer IWU was not mentioned. The correct figure captions appear below. Figure 11. Photomicrograph of a longitudinal section of a multi-scale structured contour joint with an inner [(±70°) ₅] bandage. Photomicrograph provided by Fraunhofer IWU. Figure 12. Photomicrograph of a cross-section of a meso-structured contour joint without a [(±70°) ₅] bandage. Photomicrograph provided by Fraunhofer IWU. Figure 11. Photomicrograph of a longitudinal section of a multi-scale structured contour joint with an inner [(±70°) ₅] bandage. Photomicrograph provided by Fraunhofer IWU. Figure 12. Photomicrograph of a cross-section of a meso-structured contour joint without a [(±70°) ₅] bandage. Photomicrograph provided by Fraunhofer IWU. Raik Grützner (Fraunhofer Institute for Machine Tools and Forming Technology IWU) was not included as an author in the original publication. The added acknowledgements section appears here. Acknowledgments: The authors gratefully acknowledge the provision of photomicrograph images of the contour joint by Raik Grützner of the Fraunhofer Institute for Machine Tools and Forming Technology IWU. Acknowledgments: The authors gratefully acknowledge the provision of photomicrograph images of the contour joint by Raik Grützner of the Fraunhofer Institute for Machine Tools and Forming Technology IWU. The authors apologize for any inconvenience caused and state that the scientific conclusions are unaffected. The above corrections were approved by the Academic Editor. The original publication has also been updated.