Post-tensioning of glass beams: Analytical determination of the allowable pre-load

Publikation: Beitrag in FachzeitschriftForschungsartikelBeigetragenBegutachtung



The effectiveness of post-tensioning in enhancing the fracture resistance of glass beams depends on the level of compressive pre-stress introduced at the glass edge surface that will in service be exposed to tensile stresses induced by bending. Maximum pre-load that can be applied in a post-tensioned glass beam system, yielding maximum compressive pre-stress, is limited by various failure mechanisms which might occur during post-tensioning. In this paper, failure mechanisms are identified for a post-tensioned glass beam system with a flat stainless steel tendon adhesively bonded at the bottom glass edge, including the rupture of the tendon, glass failure in tension and adhesive/glass failure in the load introduction zone. Special attention is given to the load introduction failure given that the transparent nature of glass limits the use of vertical confinement usually applied in concrete. An analytical model for determination of the allowable pre-load in post-tensioned glass beams is proposed, based on the model applied for externally post-tensioned concrete beams. The model is verified with the results of a numerical model, showing good correlation, and applied in a parametric study to determine the influence of various beam parameters on the effectiveness of post-tensioning glass beams.


Seiten (von - bis)233–248
FachzeitschriftGlass Structures and Engineering
PublikationsstatusVeröffentlicht - 30 März 2021

Externe IDs

ORCID /0000-0002-4042-7987/work/97518314
Scopus 85103401398


Forschungsprofillinien der TU Dresden

Fächergruppen, Lehr- und Forschungsbereiche, Fachgebiete nach Destatis

Ziele für nachhaltige Entwicklung


  • post-tensioned glass beams, pre-load introduction, Failure modes, Analytical model, Numerical model, Parametric study, failure modes